H A R D W A R E I N S T A L L A T I O N
Data Device Corporation
SB-36230KX Manual
Rev G – 4/19
11
If the PC does not have an unused “peripheral power connector” cable, please obtain
a Y-cable. The Y-cable is used for splitting a used connection to provide one
additional power connector.
Figure 4. Supplemental Power Connector Location
3.3 SB-3623x LED status
SB-3623x has 5 LEDS located in the upper top left corner on the card. CR2, CR3, CR12, CR13,
CR10. These LEDs are used to indicate the status of the cards FPGA during factory
programming. These LED’s are intended for factory use only.
3.4 Synchro / Resolver Signal Connections
Each channel can be configured for either Synchro, Differential Resolver, or Single-
Ended Resolver outputs. See Table 2 below for the different signal connections. Refer
to Table 9 for the connector pinout.
