Assembling the struts
4
The
strut
will look
like this to begin
with - it needs to
be extended.
Slot the 2 halves
of the strut pole
into each other.
Push the central
mechanism up until
the 3 support arms
are at right angles
to the strut, and the
cord is taut.
Take the loose cord
with the toggle on
the end.
Put it through the
loop on the top end
of the strut.
Push the central
mechanism down
until the toggle cord
is taut.
To anchor the
guyline ground plates
follow the instructions below (please make sure the ground
plates are top side up):
Anchoring the guyline ground plates
3
Spacer cord
Guyline
Step 1
Step 4
Step 2
Step 6
Step 5
Step 3
Step 8
Step 4
Step 1
Step 7
Step 5
Step 4
Step 3
Step 2
Bring the plastic ball on
the end of the
guyline
through the middle of the
guyline ground plate
.
Pull through around 10cm to
wrap around the
pegs
later.
Insert the first
peg
vertically into hole opposite to
the guyline and push it down
as hard as you can.
Please do
not stand on the pegs
as this
might bend them.
Insert the second
peg
at an
angle, crossing behind the
first
peg
.
Insert the third
peg
so that
the vertical
peg
is trapped
between the other 2 pegs.
All pegs should be firmly in
the ground
without being
pushed all the way.
Take the ball on the end of the
guyline
and wind it all the way around the 3
pegs
.
Loop the
guyline
exactly as shown (if
not, the ball will pop out) and pass the
ball through the loop.
Tug the
guyline
to
secure the knot.
Do exactly the same on all the
guyline ground plates
.
Once you have pegged all 4
guyline ground plates
out you wil be 2
pegs
short. Remove them from the
strut ground plates
.
4
5
3
4
