10
INSTALLATION INSTRUCTIONS
MOUNTING INSTALLATION
The lower rear corners of the cabinet need to provide proper support to the back of the Warming Drawer and the
anti-tip mounting clips. A 120 volt AC 15 amp (GFI) outlet should be located no further than 36 inches from the
back center of the Warming Drawer. Illustrations suggest one possible bottom support, but the consumer is not
limited to this idea for mounting configuration.
STEP 1
The bottom rear section of the cabinet should be made of moisture protected lumber and needs to be installed
to hold the anti-tip mounting clips and support the weight of Warming Drawer, which is 90 lbs. A pair of supports
located as shown on the previous pages is recommended to allow water to drain from drawer once installed.
STEP 2
Use the screws provided to attach the mounting clips which must be installed for anti-tip safety to the bottom
support at the back. See placement dimensions in Fig. 05 and Fig. 06.
STEP 3
The Warming Drawer has slots on the back side where it will slide onto the anti-tip mounting clips.
Plug power cord into the AC outlet. See figure 06.
STEP 4
Fasten the front face to the cabinet by passing the screws through the 2 holes of the front face of the warming
drawer to finish the installation. See figure 07.
NOTE: The bottom support made of moisture protected lumbar runners or other moisture pro-
tected construction must be capable of supporting the weight of the warming drawer. A drain hole
MUST be provided for drainage.
Slide drawer
on to Anti-Tip
mounting clips
mounting clips
21 3/8" (proud installation) or 23 3/8" (flush installation).
Center line
to Center line
for mounting clips
21 1/8" (536mm)
Fig. 05