DCS RGSC-305, Руководство пользователя, Страница: 21 / 58

PRELIMINAR
Y
21
COMPONENT ACCESS
OVEN DOOR REMOVAL
1. Open the door in the full open position.
NOTE: Light pressure
may have to be
applied on the
door to close
the hinge latch-
es.
2. Rotate locking tabs on
hinges so that bottom and
top are locked together
(fig. 21).
3. The door can then be
removed by lifting and
pulling the door on
approximately 60º angle
with the hinges up and out
of the front frame (fig. 22).
WARNING:
The door is about 33 pounds.
NOTE: If in event that the oven door comes off track, or
becomes misaligned, the door MUST be removed from
the range in order to reset the hinges. Open the door to
the broil stop. Get a firm grip on the door. Remember the
door is heavy. Lift the door and pull at the same time to
remove the range. It is normal to hear a loud bang when
the door is being removed. Once the door has been
removed, lay it down on a protected floor with the handle
down. With protection on your hand, lean over the top of
the door and push the large hinge away from the door to
connect the small hinge to the large hinge using the lock.
Note that the longer arm is spring loaded and is VERY
hard to move. Once the hinges are set, the door can be
reinstalled. Place the door at the same angle when it was
removed. Evenly slide the door back into place and check
to assure the hinges rest in the center of each door hinge
roller. With the oven door fully open, unlock the hinge
latches and the door is ready to close again.
If this procedure does not correct the misalignment,
contact DCS Customer Care Center (See page 51).
KICK PANEL REMOVAL
1. Disconnect power supply
2. Remove the two (2) Phillips head screws securing kick
plate (fig. 23).
3. Pull the bottom of the kick panel out to unsnap clips
and remove.
BAKE IGNITER
1. Disconnect power supply
2. Follow step in door and kick panel removal (fig. 21, 22,
23).
3. Remove oven racks and oven floor by slipping floor
forward and up to remove (fig. 24).
4. Locate igniter, remove screw.
Gently pull igniter out of location (fig. 25).
DOOR HINGE ROLLER
Fig. 21
Lock
(close)
Unlock
Fig. 22
Fig. 23
Clip
Screws
OVEN
BOTTOM
Fig. 24