
22
CARE AND MAINTENANCE
BURNERS
For proper lighting and performance keep the burners
clean. It is necessary to clean the burners if they do not
light even though the igniter clicks, if there has been a
severe boil over, or when the flame does not burn blue. Be
certain all burner knobs are in the off position before
attempting to clean the burners. The burners have been
designed for ease in cleaning. When the grates and burners
are cool, remove the grate. The burner cap and the port
ring can easily be lifted off. Wash these parts in hot soapy
water, rinse and dry thoroughly. The burner caps are
porcelain enamel, follow the directions on the previous
page that were given for the burner grates. A bristle brush
can be used to clean out the toothed burner ports, if
necessary.
DUAL FLOW CENTER BURNER
Disassembly of the simmer ring is not recommended,
however, it may become necessary to do so if the ports
remain clogged after normal cleaning. If it is necessary to
disassemble the simmer ring from the base, remove the hex
nut at the top of the simmer ring. Clean the simmer ring
with hot soapy water using a soft wire or plastic bristle
brush then dry thoroughly. Re-assemble the parts using the
hex nut. After cleaning, it is important to make sure the
locating pin on the bottom side of the simmer ring is
properly aligned with the corresponding hole in the
base and that the two locating pins (see insert-
Fig.12b) in the bottom side of the port ring are
properly aligned with the locating notch and center
holes on the top side of the simmer ring. Incorrect
alignment will produce a potentially dangerous flame
and poor burner performance (see Fig. 12a and 12b).
IGNITERS
Wipe with a rubbing alcohol dampened cotton swab.
Be careful not to damage the igniter (see Fig. 13).
SUMP AREA AROUND BURNERS AND
IGNITERS
Remove grates. With a warm wet sponge, apply a
soap that will release grease (like Dawn). Clean up
soiled area around the sump.
Fig. 13
IGNITER (KEEP CLEAN)
CAP
MAIN
BURNER
PORT RING
BURNER
BASE
IGNITER
VENTURI
LOCATING PIN
HOLE INSIDE
HEX NUT
Fig. 12a
LOCATING PIN
CAP
MAIN
BURNER
PORT RING
BURNER
BASE
SIMMER
RING
IGNITER
VENTURI
LOCATING PIN
HOLE INSIDE
LOCATING PIN
HEX NUT
LOCATING PIN
Fig. 12b
Dual Flow Burner
Single Flow Burner
Содержание RGB-305
Страница 1: ...THE PROFESSIONAL RGB 305 GAS RANGE Use and Care Guide MODELS RGB 305 ...
Страница 2: ......