Instruction manual HR2026 RECHARGEABLE SHAVER
dcg16.it
5
Maintenance
1. Remove the protective cover of the grid
2. Press the button (located under the head) to separate the shaver head and
body.
3. Also press the button on the back of the unit to remove the trimmer.
4. Remove the beard hairs with the brush provided and, if necessary, use a
damp cloth to clean the body.
5. After cleaning, reassemble the razor head with body in accordance with
the initial position and place the trimmer on the original position.
6. Replace the cover.
Charging
1. Push the switch down and close electrical power.
- The charging indicator is on, which shows that it is charging.
2. After 2H, charging is over. Charging power is 220-240V~ 50/60Hz.
3. At first using, be sure the scored power is completely out, before charging,
which can durable the battery.
* Before cleaning switch the device off with the on/off switch. Open the
battery compartment. Take the cleaning brush out of the holder on the
battery compartment over and remove the battery form the battery
compartment.
* Turn the shearing head to the left to loosen it and then pull it out. Pull
out the shearing blade with caution. Warning: the cutting blade is sharp!
DANGER OF INJURY!
* Brush the shearing head and clamp in a star-shaped manner. Remove
even the smallest bits of hair by blowing.
* Mount the shearing head back on the drive shaft of the device and screw
it on b turning to the right.
* After cleaning insert the cleaning brush back into the holder, insert the
battery and close the battery cover.
* Push the protection cap back on the shearing head.
