Auxiliary Handle
Always be sure that the auxiliary
handle is installed securely before
operation.
Screw the auxiliary handle securely
on the position of the tool as shown
in (Fig. 7)
MAINTENANCE AND INSPECTION
CAUTION:
Always be sure that the tool is switched off and unplugged before carrying out any
work on the tool.
1.
Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly
tightened. Should any of the screws be loose, retighten them immediately.
Failure to do so could result in serious hazard.
2.
Maintenance of the motor
The motor unit winding is the very “heart” of the power tool. Exercise due care
to ensure the winding does not become damaged and /or wet with oil or water.
3.
Inspecting and replacing the carbon brushes
Remove and check the carbon
brushes regularly. Replace when
they wear down to the limit mark
(6mm or 4 inch) (Fig. 8). Keep the
carbon brushes clean and free to slip
in the holders. Both carbon brushes
should be replaced at the same time.
Use only identical carbon brushes.
Use a screwdriver to remove the brush
holder caps. Take out the worn carbon
brushes, insert the new ones and secure
the brush holder caps. (Fig. 9)
※
※
※
※
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by authorized service centers, always using original
replacement parts.
-9- -10-
