INSTRUCTIONS FOR OPERATION
Installing or Removing Stirring Paddle
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or
removing stirring paddle.
To install the stirring paddle, screw the stirrer
into the drive spindle and tighten the lock nut
securely. (
Fig. 1
)
To remove the stirring paddle, follow the
installation procedures in reverse.
Switch Action
To start the tool, simply pull the switch
trigger, release the switch trigger to stop the
tool. (
Fig. 2
)
CAUTION:
Before plugging in the tool, always check
to see that the switch trigger actuates
properly and returns to the
“OFF” position when released.
Change the direction of rotation only when the tool comes to a complete stop.
Changing it before the tool stops may damage the tool.
Auxiliary Handle
Screw the auxiliary handle to the tool securely.
(
Fig. 3
)
CAUTION:
Always use auxiliary handle for safe operation.
Stirring Operation
When start stirring operation, put the stirring paddle into the material to be stirred firstly
before switching on the tool; And when stop operation, switch off the tool firstly and
wait until the tool has come to a complete stop before pulling the stirring paddle out.
CAUTION:
Change the stirring operation only when the tool has come to a complete stop.
Move the tool up and down while stirring.
Clean the stirring paddle after use.
MAINTENANCE AND INSPECTION
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to
perform inspection or maintenance.
1.
Inspecting the Mounting Screws
Regularly inspect all mounting screws and ensure that they are properly tightened.
Should any of the screws be loose, retighten them immediately. Failure to do so
could result in serious hazard.
2.
Maintenance of the Motor
The motor unit winding is the very
“heart” of the power tool. Exercise due care to
ensure the winding does not become damaged and /or wet with oil or water.
-5- -6-