5-Channel Bluetooth Looper
–
User Manual
©2019 DC Pedals. All Rights Reserved. r3.1
Page 6 of 12
MIDI CC ID Description
Values
70
Control Loop 1
0-63 Loop is OFF
64-127 Loop is ON
71
Control Loop 2
0-63 Loop is OFF
64-127 Loop is ON
72
Control Loop 3
0-63 Loop is OFF
64-127 Loop is ON
73
Control Loop 4
0-63 Loop is OFF
64-127 Loop is ON
74
Control Loop 5
0-63 Loop is OFF
64-127 Loop is ON
75
Control TRS TIP
0-63 TIP is OFF
64-127 TIP is ON
76
Control TRS RING
0-63 RING is OFF
64-127 RING is ON
77
Control Tuner
0-63 Tuner is OFF
64-127 Tuner is ON
78
Remote Save
0-100 Saves current setting to preset
82
State Set
Sets the state of
the loops and TRS
in once MIDI CC
message
Binary map of the Loops state. Bitwise
field with bits:
0 = MIDIPCFlag
1 = Loop1
2 = Loop2
3 = Loop3
4 = Loop4
5 = Loop5
6 = TRS Tip
7 = TRS Ring
8 = Must be zero!
MIDI CC Messages
Bank and Folder will be set automatically according to the received preset number. The looper will
automatically be set to Preset Mode after receiving a MIDI PC message.
MIDI Control Change Messages:
The Looper will respond to MIDI CC
messages sent on the MIDI Input Channel.
The Loops and TRS functions can be
controlled as well as remote saving of a
preset. See the table below for the CC IDs
and responses. Response to MIDI CC
messages can be turned off via the MIDI CC
Receive configuration parameter in the
Looper configuration pages. See the
Configuration
section
for
more
information.
Looper Mute:
The mute feature is OFF after the Factory
Reset. If there are significant pops or
noises while switching loops, activate the
Mute feature to reduce the noises.
However, some audio signal is lost when
the Mute is ON. The short mute time is
about 7ms and the long time is about
24ms. Choose the shortest time that
reduces the noises.
Looper Configuration:
There are many configuration options to configure the Looper for your needs. The configuration pages are
accessed during power-up. To access the configuration pages, hold the Mode switch during power-up. The
Mode LED will toggle while the switch is held. Release the switch and the Looper will enter Configuration
Mode. While in Configuration Mode, the Mode LED indicates the active configuration page. There are five
configuration pages. Press the Mode switch to cycle through the five configuration pages.
Содержание 5-Channel Bluetooth Looper
Страница 1: ...User Manual...
