dbx Zone Pro 1260, Руководство пользователя, Страница: 52 / 75

Applications Notes
44
SECTION 6
ZonePRO ™
The Input Link Buss allows the first six inputs from unit to be sent via a piece of CAT5 cable
to the second, third or more units. Simply get a short piece of CAT5 cable cut to the appro-
priate length and place one end in the Link Output RJ-45 connector of the unit sending the sig-
nals and the other end in the Link Input RJ-45 connector of the unit receiving the signals. If
there are signals that you do not want to send down you can either open those connections on
the piece of CAT5 or you can use the internal jumpers on the two mic/line inputs to disable the
link input for those signals (see Appendix A.4).
The ZC-3 and ZC-4 can be used as a scene selector. To do this they must be setup as such in
the ZC Configuration page of the Configuration Wizard. If you select a ZC-3 or ZC-4 in ID#1
you can select a check box for Scene selection. The Edit button allows selection of the indi-
vidual scenes that will be loaded for each switch position of the ZC-3 or ZC-4.
The ZC-FIRE is a special case of Scene selection allowing either muting of the entire system or
the recall of a specific Scene. To use a ZC-FIRE you must place it in the ID#2 position of the
ZC Configuration page of the Configuration Wizard. You can then select the Edit button and
choose whether you want the ZC-FIRE to be active High or Low, and select whether you want
to either mute all outputs, or load a specific scene.
6.3 - Using the ZC Fire
6.2 - Using the ZC as a Scene Selector
6.1 - Using the Input Link Bus
ZonePRO™ User Manual