WARNING FOR YOUR PROTECTION PLEASE READ THE FOLLOWING:
KEEP THESE INSTRUCTIONS
HEED ALL WARNINGS
FOLLOW ALL INSTRUCTIONS
CLEAN ONLY WITH A DAMP CLOTH.
DO NOT BLOCK ANY OF THE VENTILATION OPENINGS.
INSTALL IN ACCORDANCE WITH THE MANUFACTURERS
INSTRUCTIONS.
DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADI-
ATORS, HEAT REGISTERS, STOVES; OR OTHER APPARATUS
(INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.
ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE
MANUFACTURER.
UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR
WHEN UNUSED FOR LONG PERIODS OF TIME.
WATER AND MOISTURE: Appliance should not be used
near water (e.g. near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, or near a swimming pool,
etc). Care should be taken so that objects do not fall and liq-
uids are not spilled into the enclosure through openings.
POWER SOURCES: The appliance should be connected to
a power supply only of the type described in the operating
instructions or as marked on the appliance.
GROUNDING OR POLARIZATION: Precautions should be
taken so that the grounding or polarization means of an
appliance is not defeated.
POWER CORD PROTECTION: Power supply cords should
be routed so that they are not likely to be walked on or
pinched by items placed upon or against them, paying par-
ticular attention to cords at plugs, convenience receptacles,
and the point where they exit from the appliance.
SERVICING: To reduce the risk of fire or electric shock, the
user should not attempt to service the appliance beyond that
described in the operating instructions. All other servicing
should be referred to qualified service personnel.
FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSI-
BLE FUSE RECEPTACLE: Replace fuse with same type
and rating only.
MULTIPLE-INPUT VOLTAGE: This equipment may require
the use of a different line cord, attachment plug, or both,
depending on the available power source at installation.
Connect this equipment only to the power source indicated
on the equipment rear panel. To reduce the risk of fire or
electric shock, refer servicing to qualified service personnel
or equivalent.
POWER ON / OFF SWITCH: The Power Switch used in this
piece of equipment DOES NOT break the connection from
the Mains.
SAFETY INSTRUCTIONS
NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD.
WARNING: THIS APPLIANCE MUST BE EARTHED.
CAUTION: EQUIPMENT IS NOT DISCONNECTED FROM MAINS WHEN SWITCH IS
IN THE OFF POSITION
The cores in the mains lead are coloured in accordance with the following code:
GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live
As colours of the cores in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals in your plug, proceed as follows:
• The core which is coloured green and yellow must be connected to the ter-
minal in the plug marked with the letter E, or with the earth symbol, or
coloured green, or green and yellow.
• The core which is coloured blue must be connected to the terminal marked
N or coloured black.
• The core which is coloured brown must be connected to the terminal marked
L or coloured red.
This equipment may require the use of a different line cord, attachment plug, or
both, depending on the available power source at installation. If the attachment plug
needs to be changed, refer servicing to qualified service personnel who should refer
to the table below. The green/yellow wire shall be connected directly to the units
chassis.
WARNING: If the ground is defeated, certain fault conditions in the unit
or in the system to which it is connected can result in full line voltage
between chassis and earth ground. Severe injury or death can then
result if the chassis and earth ground are touched simultaneously.
LIVE
E
NEUTRAL
EARTH GND
CONDUCTOR
L
N
BROWN
BLUE
GREEN/YEL
BLACK
Normal
Alt
WIRE COLOR
WHITE
GREEN
The symbols shown above are internationally accepted sym-
bols that warn of potential hazards with electrical products.
The lightning flash with arrowpoint in an equilateral triangle
means that there are dangerous voltages present within the
unit. The exclamation point in an equilateral triangle indi-
cates that it is necessary for the user to refer to the owner’s
manual.
These symbols warn that there are no user serviceable parts
inside the unit. Do not open the unit. Do not attempt to serv-
ice the unit yourself. Refer all servicing to qualified person-
nel. Opening the chassis for any reason will void the manu-
facturer’s warranty. Do not get the unit wet. If liquid is
spilled on the unit, shut it off immediately and take it to a
dealer for service. Disconnect the unit during storms to pre-
vent damage.
C A U T I O N
A T T E N T I O N :
R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R
W A R N I N G :
T O R E D U C E T H E R I S K O F F I R E O R E L E C T R I C
S H O C K D O N O T E X P O S E T H I S E Q U I P M E N T T O R A I N O R M O I S T U R E
R I S K O F E L E C T R I C S H O C K
D O N O T O P E N
IMPORTANT SAFETY INSTRUCTIONS
2
mini comp manual 8/16/01 1:48 PM Page 2
