dbRevO Wireless Tech All-in -One Design, Руководство по эксплуатации

Страница: 14 / 15

14
VI. Error Code
Error Code will flicker when control system is under abnormal conditions.
The console will be powered off automatically after Error Code flickers for 10
seconds.
Troubles And Troubleshooting
Trouble
code
Trouble Description Troubleshooting
1. To check if motor signal wire is disconnected.
E1
No speed signal from
motor during driving. 2. To replace motor.
E3
Controller fails when
motor operates
1. To replace control board.
E4
Controller fails when
motor operates. 1. To replace control board.
1. To check if Torque Sensor zeroing voltage setting is correct.
2. To check if Torque Sensor signal wire is disconnected.
E7
Torque Sensor voltage
is abnormal or out of
the scope of standard. 3. To replace Torque Sensor.
1. To check if motor signal wire is disconnected.
2. To replace motor.
E-8
UVW wire is
disconnected when
motor operates.
3. To replace lower controller.
1. To replace motor.
E-9
Short-circuit after
motor start-up
2. To replace lower controller.
1. To check if motor signal wire is disconnected.
2. To replace motor.
E-A Motor cannot operate
3. To replace lower controller.
E-B
Controller current is
over the scope of
standard.
1. To replace motor.
1. To power on the console after the battery is placed well and
switch on for 3-5 seconds.
As the console and controller are checking the battery
capacity after the battery is switched on. To power on the
console within 3-5 seconds, E-0 will flickers on the console.
2. To check if battery voltage is lower than 16V or not. If yes, to
charge the battery to full.
E-0
Battery voltage is
lower than the scope
of standard
3. To replace console
● Users shall contact with local dealers if troubles still cannot be solved under
above situations!