19
APPeNdIx A - NANO-LOk edGe sRL-Le Web LOOP HARNess AdAPTeR
The Nano-Lok edge SrL-Le Web Loop Harness Adapter (P/N 3500046) (see Figure A) is a web loop that allows the SrL-Le to be
used on harnesses that are not compatible with the SrL-Le Harness Interface connector (see Figure 2.) This applies primarily to
harnesses with fixed D-Rings that do no have enough slack in the harness web to allow the pin of the connector to pass through.
(See Harness mounting procedure, Section 3.2.)
Figure A
Figure B
Nano-Lok edge SrL-Le Web Loop Harness Adapter
(P/N 3500046)
STEP 1:
Position harness D-ring (
1
) as shown.
1
Figure C
Figure d
STEP 2:
From behind and at the bottom of the D-ring,
insert the Web Loop up through the D-ring and
fold the top of the loop down (
2
).
STEP 3:
Pull the top of Web Loop (
3
) down through the
bottom of the Web Loop.
2
3
Figure E
Figure F
STEP 4:
open the Nano-Lok edge SrL-Le Harness
Interface. Push down on the Locking Buttons
(
4
) simultaneously and slide the Locking Pin
(
5
) out.
Position the Web Loop between the sides of the
Harness Interface as shown.
STEP 5:
Insert the Locking Pin (
6
) Through the Web Loop.
Confirm that the Locking Pin has locked in the closed
position.
If properly closed, the red Band on the Locking Pin
will not be visible.
5
4
6
