www.dbtechnologies.com
VIO L210
2
Rev 1.0 cod. 420120248Q
Thank you for choosing a dBTechnologies Product!
VIO L210 is the new dBTechnologies flagship 2-way professional active line array module. It is equipped with: one
1.4” neodymium compression driver exit (3” titanium voice coil) and two 10” neodymium woofers (2.5” voice coil).
The full-range acoustical design includes an efficient waveguide and a phase plug with phase correctors, in order to
reach the best coherence in line-array configuration. The mechanical design allows an easy, accurate and quick
installation in flown or stack use. The powerful DIGIPRO
®
G3 amplifier section, capable of handling up to 900 W
(RMS power), is controlled by a DSP, which can perform a detailed customization of the output sound of the speaker.
In particular, thanks to the new dual rotary encoder interface, it is possible to accurately tune the line-array
configuration coverage, using the FIR filter technology. In addition, the integrated RDNET connections are useful for
a remote in-depth line-array control and configuration.
Check the site
www.dbtechnologies.com
for the complete user manual!
1) Unpacking
The box contains:
N°1 VIO L210
N°1 100-120 V FUSE
This quick start and warranty documentation
2) Easy installation
VIO L210 can be installed in different configurations.
For a quick installation, in each side of the
loudspeakers the user can find:
Central and rear handles for easy handling (
A
)
- Two quick-release pin connections for frontal
mounting (
B
), with upper integrated front arms.
In the rear side the user can find:
- One swing rear bracket (
C
) for line-array mounting,
with splay angles reference holes for easy setup and
two quick-release pins.
In order to mount the line array, for each module:
- Remove the upper front pins and lift the front arms
in the final position as shown.
- Fasten the arms with the pins in the lower holes.
- Put a second VIO L210 and remove the lower
frontal
pins.
- Put this second enclosure on the top of the first.
- Insert the front arms in the position shown, aligning
the related holes.
