network that allows you to select the crossover mode (Highpass—Full Range) and desired
crossover point for channels 1 and 2. Channels 3 and 4 allow you to select between a
Highpass 12db slope, a 12db Stereo Lowpass / Bandpass slope and a mono 24db Lowpass /
Bandpass slope. For example if you wish to drive a pair of subwoofers on channels 3 and 4
out the high frequencies with a 24db slope. You will then need to adjust the Lowpass
control to the desired frequency setting (make sure to have the Highpass control set to
switch to LP/BP stereo. Once the LP/BP stereo switch setting is selected you will use both
any unwanted low frequencies with a 12db slope.
The M350 , M500, M1000 and M2000 are equipped with a variable 24db slope
feature a variable Bass Boost EQ is set at 45Hz. In some subwoofer enclosure installations it
may necessary to use the Phase Shift feature. The Phase Shift button sets the Subwoofer
subwoofer enclosure. M500, M1000 and M2000 are equipped with Multi-Linking technology.
When using a single Linkable amp set the Master / Slave switch to the Master position.
the slave setting the front panel controls become inoperative. All adjustments for both
( T265, F465, F490, F4125 )
Built-in Crossover
( M350 , M500, M100 M2000
)
T265 , F465, F490 and F4125
LP/BP
12dB
Stereo
Mode
HP 12dB
High Pass
Channel 1 & 2 Over Controls
Min Max
Min Max
HP
Full
5KHz
20Hz
Gain
F465
Ch 3
Ch 3
Ch 1
Ch 2
INPUT
X-OVER
INPUT
High
Pass
Channel 3 & 4 X-Over Controls
Low
Pass
Bass
Boost
Gain
OUTPUT
Ch 4
Ch 4
20Hz 1KHz
50Hz 5KHz
0dB 12dB
LP/BP Mono 24dB
4 CHANNEL AMPLIFIER
Euphoria
Euphoria
ADJUSTMENTS AND SETTINGS
ADJUSTMENTS AND SETTINGS
FINE TUNE THE SYSTEM
