DAYRON 26057, Инструкция по эксплуатации

Страница: 17 / 35

1. Open the cardboard box and remove the components. (Figure 1).
2. Install the support plate on the ceiling (figure 2).
3. Insert the support rod through the top and bottom caps.
4. Insert the motor electrical wiring through the support rod and con-
nect them to the terminal on the top of the support rod.
5. Secure the support rod to the motor using the pin and nut (figure
3).
6. Suspend the fan on the hook on the support plate and connect
the power line wiring to the terminal on the top of the support rod.
Make sure the receiver is inserted into the mounting plate (See
“Connecting the remote control”).
7. Slide the top cover up and secure it with the screw (figure 4).
8. Slide down the bottom cap, which must be supported by the mo-
tor. Fix it with the screw (figure 4).
9. Center the slots in the blades with the heads of the blade set
screws. Slide the blades so that the head of the screws is positio-
ned at the end of the slot (figure 5).
10. Tighten the screw (figure 6).
11. Remove the screws from the motor connection plate and carefully
route all cables to the connection plate.
12. Align the holes in the back of the LED fixture and assemble the
three screws on the motor connection plate (figure 7).
13. Tighten the three screws on the LED board, link the connector with
the motor wiring. Make sure that the light kit cannot move after
tightening the screws (figure 8).
14. Place the panel on the fan (figure 9)