Daymak WILD GOOSE 60V, Руководство пользователя

Страница: 22 / 32

22
P10 : Power Modes: This determines if the Throttle works, Pedal Assist Works, or Both.
0 = Pedal Assist only Works / 1 = Throttle Only works / 2 = Pedal Assist and Throttle Works
P11
: Pedal Assist Sensitivity: Determines how much pedaling has to be done before the
PAS kicks in. 1 = Least Sensitive / 24 = Most Sensitive
P12 : Pedal Assist Starting Strength: Determines how much power is given initially from
the start of pedalling. 1 = Least Power / 5 = Most Power
P13 : Magnetic Plate Setting - Choose between 5, 8, 12 magnets. Do not tamper with
unless familiar with these units.
P14 : Controller Current - This sets the amount of power going into the controller. The
Default is 12A. Modifiying this higher than the default may ruin the controller and should
not be tampered with. Any damage done in this manner will not be covered under
warranty.
P15
: Low Voltage Threshold: This sets the voltage where the motor will automatically cut
off. (See Low Voltage chart)
P16 : Not Applicable
P17 : Cruise Control: Enables cruise control. With this enabled holding the (-)CUR button
will toggle the cruise control and braking will disable it
0 = Cruise Control Off / 1 = Cruise Control On
P18
: Speed display adjustment: This adjusts the displayed speed by a percentage to more
accurately show your current speed. Increasing this past 100 will increase the displayed
speed and decreasing will do the inverse. Default is 100%. Range 50% - 100%.
P19 : Zero Pedal Assist - Turns on and Off the Zero Pedal Assist Level.
0 = Pedal Assist starts at 0 / 1 = 1 to 3 or 5 levels.
P20 : Not Applicable.