The Vienna Electric Bicycle User’s Guide
TPS Training Bulletin
Page 14
Charging through the E-Bike
To charge the batteries through the e-bike, follow this procedure.
1.
Turn off the e-bike and remove the key from the “ignition”.
2.
Plug the female end of the charger cable into the charging slot on the e-bike. This is
found on the outside casing of the e-bike, in front of and just underneath the seat.
3.
Plug the male end of the charger power cable into your wall socket. This should be a
110v household electricity supply. You can also use a portable generator, if
necessary, but make sure it provides 110V current.
4.
Allow the e-bike’s battery to charge for the appropriate amount of time (6-12 hours).
5.
Disconnect the charger when the LED light on the charger is green. The batteries
have been fully charged.
Note
If your charger’s LED status light does not change from red to green over an extended
period of time, for perhaps more than 14 hours, and the battery is very hot, the battery
or charger may need replacing. Stop charging and bring both to your Daymak dealer
immediately. Do not charge the battery.
Charging a Battery on its Own
If you have removed one of both of the batteries to charge away from the e-bike, follow this
procedure.
1.
Follow the instructions to remove the battery from its compartment
2.
Plug the female end of the charger cable into the charging slot on the battery.
3.
Plug the male end of the charger power cable into your wall socket. This should be a
110v household electricity supply. You can also use a portable generator, if
necessary, but make sure it provides 110V current.
4.
Allow the e-bike’s battery to charge for the appropriate amount of time (3-8 hours).
Disconnect the charger when the LED light on the charger is green. The battery has
been fully charged.
Battery Care Caution
Be sure to follow all instructions concerning handling the battery found
under “Battery Care”.
Note
If your charger’s LED status light does not change from red to green over an extended
period of time, for perhaps more than 14 hours, and the battery is very hot, the battery
or charger may need replacing. Stop charging and bring both to your Daymak dealer
immediately. Do not charge the battery.
Heat Warning
A charging battery produces heat. Do not cover the battery with
anything when it is being charged, to allow the heat to escape.
Allowing the battery to overheat may cause serious damage to your
battery. If the battery is very hot to the touch, do not touch it until it has
cooled sufficiently.
