6
5.
Maintenance and adjustments
5.1 Do not attempt to open the casing of the battery, motor, or regulator or all warran-
tees will become void. If you experience a problem contact our service department.
5.2 Wheel spokes should be adjusted after 6 months. Handlebar and saddle tubes
should never be on the nuts positioning the handlebar, handlebar vertical tube, bicy-
cle saddle, saddle tube and front wheels is 18NM. The minimum torque on the nuts
on the pedal bearing axle and rear wheel is 30NM.
5.3 If the chain becomes loose or frequently comes off the front cog, you can easily
adjust the chain tension by loosening the rear axle nuts slightly, and adjusting the
tension bolts. Make sure that the chain runs freely and re tighten the axle nuts.
5.4 The brake leavers should lock the wheels when compressed half way between
their open position and touching the handlebars. When the need adjusting use the
following methods:
Front brake: Loosen the nuts the cable clamp, then tension or release the steel cable,
until the gap between the wheel and brake rubber is 1.5 to 2.0 mm.
Rear brake: Loosen the nuts on the cable clamp, then tension or release the steel
cable until you can feel the brake lever’s motion is fl uid and does not lock the back
wheel until it is the correct position.
Warning: Braking distances increase on wet or icy roads.
5.5 Regularly lubricate the gears and chain with light oil and the brake bushes (not
the rubber brake shoes) with a little grease.
6.
Introduction to Main components/parts
1.front light
10.battery
2.gear lever
11.controller
3.brake lever
12.PAS
4.fork
13.battery
lock
5.brake cable
14.rear derailleur
6.disc brake
15.gears
7.quick release
16.motor
8.seat post
17.rear brake
9.quick release
Содержание Paris 48V
Страница 1: ...Paris 48V User Manual...
