DAYLIFF DSTEAM120, Инструкция по установке и эксплуатации

Страница: 13 / 24

4.4 Installation of Controller and Temperature Probe
Steam generator controller is water proof and can be installed inside or outside the steam
room according to customer preference.
1. The control panel should be installed at a height of approximately 1200mm for ease
of use.
2. To Install: drill a
Φ
40mm hole on wall. Open the front cover of steam generator. Fix
the control cable (6 core) and temperature sensor cable (2 cores) to the relevant
ports. Put the protruding back of controller in the hole at the bottom of controller press
close to the wall and place back the cover.
Control panel installation: Screw one end to circuit board ports in steam generator
and connect the other to the controller's cable.
Fig 9: Controller Installation
118mm
Temperature probe installation: The temperature probe is installed inside the
steam room at approximately 1.2 to 1.5 meters high and away from the door respective.
Use a
Φ 4mm screw to fix it in place and connect to the wire from the controller.
10
Temperature
Sensor
4
Screw
Installation for Power Supply and Control Cable
1. Confirm the correct voltage of power supply and the wires.
2. Remove the knock out for the power cable entry and use a rubber grommet to protect
the cable, connect the conductors to the correct terminals. For single phase power
use the copper bridge connectors.
3. Ensure the power supply wire and control cable remains separated to prevent
magnetic field of power supply wire from interfering with control cable signal.
4. Connect the drain outlet to a suitable drain via a copper pipe with the appropriate
fittings.
5. Make a secure connection between steam nozzle & steam pipe.
6. Use non corrosive hose with ½ inch unions to connect between the descaling liquid
container and the inlet valve; note the descaling liquid container must be mounted at
least 500 mm above the steam generator.