Dayi Motor E-ODIN 2.0, Инструкция по эксплуатации

Страница: 10 / 18

9
Nuts & Bolts -Look over entire scooter for loose nuts and bolts. Tighten if needed.
Check the following items after you get on the scooter:
6.4 Safe riding precautions
Before riding this scooter, be sure you have read this entire manual up to this
point including the section titled: Important Safety Information & Before Riding.
Always practice in a safe area until you have built your skill level to a point at
which you can safely ride the scooter.
6.5 Method for correct operation
6.5.1 Riding method
(1) Keep the natural posture, and free driving can be got. Driving in sitting posture:
please always keep your body at the center of the cushion to prevent load
reduction of the front tyre and danger caused by handlebar vibration.
(2) Driving slowly on roads with surface damaged or that paved with gravels.
In raining or snowy day, wet ground will easily cause side slip, so you should drive
it slowly with much attention.
6.5.2 Parking method
(1) When parking, please pay attention to those vehicles and pedestrians around.
Park it to the right side of flat road slowly, do not park it on a slope.
(2) After parking it stably, turn the power supply lock rightwards to pull it out and
take it down, and then lock the scooter with a lock.
6.5.3 Operation method for electricity indication
(1) After the power supply lock is connected, the voltage indicator light will be
turned on. There are several electricity indications, when you find the electricity
indication is too low, you should charge the scooter immediately.
6.5.4 Operation method for power supply lock
During driving, you do not remove the key and switch off power supply, nor can
you turn the key in counterclockwise direction to close the power supply lock.
Once you switch off the power supply, the motor will stop running. After parking,
you should turn the power supply lock in counterclockwise direction to switch off
the power supply, and then pull the key out.
6.5.5 Turning handle (speed-governing handle)
No matter under natural start model or push start model.
If the turning handle is turned towards the driver, the scooter will be speeded,
and if it is released to turn back, the speed will be reduced. After reset, cut off the
power supply of motor.