Voyager serial
Daxten Ltd
4 Harp Business Centre
Apsley Way
London NW2 7LW
Tel.: +44 (0)20 8438 3800
Fax: +44 (0)20 8438 3899
[email protected]
www.daxten.co.uk
Baud Rate Selection
The daughterboard in the Remote unit has a jumper which is used to select between baud
rates of 9600 (default) and 19200. Refer to the drawing below for the location of this
jumper. Ensure the Rmote Unit is powered down before changing the jumper setting.
Hardware Flow Control
Most applications for the serial link will not require hardware flow control and therefore
However, the daughterboards in both the Local and Remote Units have a series of
jumpers which allow the selection of two alternative hardware flow control schemes
across the CAT5 link, or local loopback of the flow control lines for those PC’s and
peripherals that require the presence of a handshaking control signal to enable them.
Do not alter the position of any jumpers or headers on the daughterboard except for
those described above and whose locations are shown below.
Serial
Daughter
Board
Use with a Serial Mouse
As standard the serial link does not support a serial mouse. If you have a PC which does
not have a PS/2 mouse port you should plug a PS/2 mouse into the Remote Unit and use
it is not enabled by default.
a 2146-00C PS/2-Serial Mouse converter at the CPU side. If however, you have a special
serial mouse device such as an industrial trackball which is not available with a PS/2
interface it may be possible to use it through the extender if a custom firmware revision is
supplied. Please contact technical support for details.
Dual Unit (Model 1035-21R) Specific Notes
Please note that the remote serial link is always active even if the Local console is
selected.
