4
WARM, THEN DON THE EZ-ACCESS DAW
SKIN
1. Warm Using Oven Or Hair Dryer (DO NOT OVERHEAT)
Warming in Oven
(Recommended)
Heat oven to 120-Degrees. Place DAW
SKIN
on edge of oven with door open.
Warm for 90 seconds, then flip. Warm other side for 90 seconds.
Warming with Hair Dryer
(NOT A HEAT GUN)
Thoroughly warm the DAW
SKIN
with a hair dryer to 120º F (5º C).
Use of a heat gun will damage the DAW
SKIN
(cracking will occur,
though it will not be immediately apparent).
2.
Don the EZ-Access DAW
SKIN
as you would a stocking.
While still warm,
carefully stretch DAW
SKIN
over the heel. Then pull fully up the leg all the way above
the socket brim.
NOTE:
For continuous AK covers, check proper
tension by bending knee and straightening, wrinkles
should disappear in seconds
3.
Apply 3/4in (2cm) masking tape on EZ-Wrap all the way
around at the top edge of the DAW
SKIN
. (Img.
A
)
4.
Fold over top 1in (2.5cm) of EZ-Access DAW
SKIN
. (Img.
B
)
5.
Apply S-Glue “Release Formula” on both the exposed
EZ-wrap below the tape and the folded over portion
of the DAW
SKIN
. (Img.
B
)
6.
Let glued on surfaces reach a stage of dry-tacky.
(approximately 2 minutes).
7.
Unfold the top of the DAW
SKIN
back over The
EZ-Wrap and apply slight pressure.
8.
Remove masking tape.
9.
Prosthesis can be dispensed immediately.
Warming the DAW
SKIN
makes it much easier
to pull over the heel and onto the leg.
Masking Tape
EZ-Access
DAWSKIN
Masking Tape
EZ-Access
DAWSKIN
S-Glue
Release
Formula
Img.
A
Img.
B
STEP
Pg. 5
