To assemble:
1.
Turn the radiator upside-down on a soft surface (i.e., a rug), to prevent damage to the
paint finish or your floor surfacing.
2.
Fit the two (2) Feet onto the radiator by placing the arc-shaped brackets between the
outermost fins on each side of the radiator.
3.
Securely fasten the two (2) Feet onto the radiator by screwing two (2) Wing Nuts
onto each Foot.
CAUTION: Only operate the radiator in normal upright position with wheels and
stand assemblies attached to the bottom of the unit (wheels on the bottom, controls
on the top), any other position could create a hazardous situation
The annexation of the device’s cable is X type with special set wire way
To operate:
1.
Place the product on a flat, steady, stable, heat-resistant surface.
2.
Plug the Power Cord into a standard 230V AC electrical outlet.
3.
Turn the thermostat knob clockwise to a position on its range.
4.
Press the power switches buttons either to “I” (Low heating) or “II” (Medium heating)
or both “I+II” (High heating) position. (Fig. B)
5.
Allow the heater to warm up until the ambient room temperature reaches your desired
comfort level.
Fig. B.
--SAVE THESE INSTRUCTIONS--