Page 3 of 4
Before using your kettle
If you are using the kettle for the first time, it is recommended
that you clean your kettle before use by boiling a full kettle of
water twice and then discarding the water.
Operation of your kettle
1. To fill water kettle, remove it from the power base and open lid,
fill with the desired amount of water to the water kettle. Always
fill the kettle between the minimum (0.5L) and maximum (1.7L)
marks. Too little water will result in the kettle switching off before
the water has boiled.
NOTE
: Do not fill the water over the maximum level, as water
may spill out of the spout when boiling. Ensure that the lid is
firmly in place before
connecting the power cord to the outlet
.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Press the switch button
below the handle. The indicator will light up. Then start to boil the
water. The kettle will switch off automatically once the water has
boiled. You can shut off the power by lifting the switch button at
any moment during boiling water.
NOTE
：
Ensure that switch is clear of obstructions and the lid is
firmly closed
，
The kettle will not turn off if the switch is
constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
NOTE:
operate carefully when pouring the water from your
kettle
，
as boiling water will scald.
5. The kettle will not re-boil until the switch is pressed. Allow to
cool for 15~20 seconds before reopening to boil water. The kettle
may be stored on the power base when not in use.
NOTE
：
Ensure power supply is turned off when kettle is not in
use.
Should you accidentally allow the kettle to operate without water,
the boil-dry protection will automatically switch it off. If this
should occur, allow the kettle to cool before filling with cold water
and re-boiling.
Care And Cleaning
Always disconnect the appliance from the power outlet before
cleaning.
