Alarm Activation
This command determines whether an output for an activated alarm is
continuous throughout the activation time or a one time pulse. The default is
continuous activation. Pulsed relay oriented devices will require the one-time
pulse.
Circuit Behavior
This command determines whether the circuit stays open or closed when no
alarms are active. The opposite behavior occurs for an active alarm
condition. Default is normally open. Choose normally open if you want the
Alarm Output data logger to leave an electrical device OFF unless an alarm
condition occurs. Choose normally closed if you want the Alarm Output data
logger to leave an electrical device ON unless an alarm condition occurs.
Normally open mode conserves console or Envoy battery power.
Default
Press this button to restore the data entries to their default values. You must
still hit OK to save the settings in the data logger.
Output
Select the appropriate tab (Output 1 – 4) to configure the alarm settings for
each output.
For each output, first select the first parameter you want to test. For the
Minus check type, you will need to select a second parameter after you
select the Minus check type.
11