DAVIS 8240 Скачать руководство пользователя страница 2

Configuring CarChip Fleet with Alarm

Configuring CarChip Fleet with Alarm

1.

Select the 

Set CarChip LED State

 command in DriveRight FMS CarChip menu. 

The 

Set CarChip LED State

 command controls the alarm and LED functions.

2.

Select Enable to turn ON the alarm and LED, or select Disable to turn OFF the 
alarm and LED. 

The alarm functions in the following manner:

One beep when initially connected to the vehicle’s OBDII port.

Two beeps when the vehicle’s OBDII protocol is identified.

Five beeps for each acceleration & deceleration violation.

Continuous beeps when violating the speed limit.

Note:

The LED functions the same way in both CarChip Fleet models.

Installing CarChip

Use these instructions to install CarChip in your vehicle’s OBDII port.

1.

Find the OBDII port on your vehicle.

The OBDII port will be located within 3 feet of the steering wheel within or 
near the general area indicated by the dotted line in the illustration below. The 
port should be easily accessible to a person in the driver's seat. 

If you have trouble finding the OBDII port, be sure to check the following 
areas: 

Under the dash

In front of the passenger seat

Behind the ash tray

Behind a small access panel in the dash

In or around the center console

OBD II Port

Содержание 8240

Страница 1: ...eet or CarChip Fleet with Alarm in your vehicle we recommend that you add the device to the database in the DriveRight Fleet Management Software FMS and check the CarChip settings 1 Connect CarChip to your computer See instructions on page 3 2 Add the CarChip to your DriveRight FMS database Note Refer to the DriveRight FMS Help or User s Manual for instructions on using DriveRight FMS 3 In DriveRi...

Страница 2: ...eleration violation Continuous beeps when violating the speed limit Note The LED functions the same way in both CarChip Fleet models Installing CarChip Use these instructions to install CarChip in your vehicle s OBDII port 1 Find the OBDII port on your vehicle The OBDII port will be located within 3 feet of the steering wheel within or near the general area indicated by the dotted line in the illu...

Страница 3: ...hip Fleet to a serial port on your computer using the hardware and cables as shown below 1 Locate a free serial port on the back of your computer and insert the 9 pin connector of the download cable into the port 2 Plug the power adapter cable into the power jack on the 9 pin connector 3 Plug the power adapter into an AC outlet 4 Plug the 8 pin microminiature connector into the port on the CarChip...

Страница 4: ...llation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment on and off the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circui...

Отзывы: