3
Mounting on a Pole
Use a pole having an outside
diameter between 1
"
and 1-1/4
"
(25 – 31 mm).
1. Hold the mounting bracket
against the pole. Put two
U-bolts around the pole and
insert the ends through the
holes in the back of the
mounting bracket.
2. Secure the mounting bracket
using 1/4" flat washers, lock
washers and 1/4" hex nuts
Tighten all four sets of
washers and hex nuts until the
mounting bracket is firmly
mounted on the pole.
3. Use the longer cable tie to
secure the coil of unused
cable. Use the 8”cable ties to
secure the uncoiled sensor
cable to the pole to prevent fraying in wind.
Mounting on a Post
1. Using four 1/4" x 1-1/2" lag
screws, attach the mounting
bracket to the surface in the
desired location. Drill holes
using a 3/16" (5 mm) drill bit.
Use a carpenter’s level when
marking the holes to ensure
that the bracket will be level.
2. Using an adjustable wrench or
7/16" wrench, tighten the lag
screws.
3. Use the longer cable tie to
secure the coil of unused cable.
Use the 8”cable ties to secure
the uncoiled sensor cable to
prevent fraying in wind.
1/4" Flat Washer
2-1/8" U-Bolts
1/4" Hex Nut
Sensor Cable
Lock Washer
1/4" x 1-1/2" Lag Screws
Sensor Cable
Содержание 6830
Страница 2: ......