6
Mount the Sensor Transmitter
You can mount the Sensor Transmitter on a pole or on a vertical surface such as a post or
wall.
Note:
If using the solar-powered model, remember to position the shelter so the solar panel has
maximum exposure to the sun
Mounting on a Pole
1. While holding the
shelter against the pole,
place a U-bolt around
the pole and through the
two holes on at the top
of the shelter.
Flat
Washer
Lock
Washer
Hex
Nut
U-Bolt
2. Place a flat washer, a
lock washer and a hex
nut on each of the bolt
ends.
3. Using an adjustable
wrench or 7/16"
wrench, tighten the
nuts.
4. Place the second U-bolt around the pole and through the two holes at the bottom of
the shelter. Put a flat washer, a lock washer, and a hex nut on each bolt end, and
tighten the hex nuts.
Mounting on a Vertical Surface
1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm) apart. Use a
carpenter’s level to ensure the holes will be level.
2. Drill two more holes 7-
1/32" below the upper
holes.
Flat
Washer
Lag
Screw
3. Insert the 1/4" x 1-1/2"
lag screws through the
flat washers, and through
the holes at the top of the
shelter into the post.
Using an adjustable
wrench or 7/16" wrench,
tighten the lag screws.
4. Insert the 1/4" x 1-1/2"
lag screws through the
flat washers, and through the holes at the bottom of the shelter into the post. Using an
adjustable wrench or 7/16" wrench, tighten the lag screws.
5. If using the AC-powered model, plug the AC-Adapter into the electrical outlet.