10
3. MEASUREMENT
3.1 Power
1.
Turn the power on. All
segments of the display will
light for 2 seconds.
2.
The vertical reading will then
be shown as
, which
stands for “SET”
3.
Rotate the telescope to set
the vertical “0” point. This is
done to cause the zero pointer
to pass a sensor and start
vertical angle measurement.
4.
Check battery power:
Full, partial and low power,
measurement is possible.
No power, no measurement
possible; replace the batteries.
Note:
Battery operating time will vary depending on type and brand and operating
temperature. Be sure to keep an extra set of alkaline type AA batteries in the carrying
case. For any other questions about the batteries, see section 4.
2.3 Aiming At The Target
Loosen the clamps and point at
the target using the targeting
sights located above and below
the telescope.
Allow some space between your
eye and the targeting sight.
R L
V %
HOLD OSET
V
-8.8.8.8.8.8.8.
H
RL
8.8.8.8.8.8.8.
G
R L
V %
HOLD OSET
V
H
R
0.0.0.0.0.0.0.
R L
V %
HOLD OSET
V
9 0 0 0 0 0
H
R
0 0 0 0 0
G
Full
Power
Partial
Power
Low
Power
No
Power
