19541P-43 (09-12)
4 of 9
L
L
i
i
n
n
k
k
i
i
n
n
g
g
Before a belt station and a gateway can be connected, they must first be
linked
. As a security
measure, the
close-link
feature requires devices to be in proximity of about 1 to 3 ft (0.3 to 0.9m)
in order to successfully link. This ensures that the units are not inadvertently linked with other
units on the premises.
Linking procedure:
1.
Ensure units are within 1 to 3 ft (0.3 to 0.9m) of each other.
2.
Simultaneously (within 1-2 sec) press and release the LINK button on the U9922-G38 and
the LINK/PTT button on the belt station to link with.
3.
Amber LED’s will flash quickly on both devices. A momentary red LED indicates a
successful close-link.
4.
Upon successful link the U9922-G38 will attempt to establish a connection with the belt
station.
5.
Upon successfully establishing connection the LED on the gateway will flash a green
pattern corresponding to the number of belt stations connected.
Tip:
Once linked, the devices will not need to be linked again unless they are purged (see
Purging
).
Each belt station is able to be linked to only one gateway at a time. A gateway can have up to six
belt stations linked and be connected to four of those six at one time.
S
S
t
t
a
a
t
t
u
u
s
s
I
I
n
n
d
d
i
i
c
c
a
a
t
t
i
i
o
o
n
n
s
s
The LINK button has a multi-color LED in the center which serves as a status indication for the
gateway.
Table 1
below lists these states.
Table 1: LED Status Indications
LED Color
Blink Rate
Status
Red
Solid
Initializing/power up
Red
Once
Connection Dropped
Red
Once
Connection Established
Red
Any
Low battery (approx. 1 hr remaining)
Orange
Slow
Idle/Disconnected
Orange
Fast
Linking/Connection in Progress
Orange
Solid
PTT asserted
Green
Slow
Connected (pattern indicates
number of belt stations connected)
