Davey PowerMaster Eco-Series, Инструкция по установке и эксплуатации

Страница: 5 / 16

5
Installation of the PowerMaster
®
ECO Series Pump:
Location
The pump should be located as close to the water as practicable and
mounted on a firm base in a well drained position, high enough to prevent
any flooding. It is the installer’s/owner’s responsibility to locate the pump
such that the nameplate can be easily read and the pump can be readily
accessed for service.
Weather Protection
It is recommended that the pump is protected from the weather. Enclosures
should be ventilated to prevent condensation build-up and allow a free flow
of air for the fan cooled motor.
Power Connection
Davey Power Master
®
is suitable for connection to a nominal 240 volt 50Hz
power supply and are equipped with a flex and 3 pin plug. If a power outlet
is not available within 3 metres of the pump, a 3 pin power point in a safe,
dry place may need to be provided by an electrician. Extension cords are
unsafe around pools - and should be avoided. If the supply cord of this
product is damaged it must be replaced by the dealer or manufacturer, with
genuine Davey spares.
This PowerMaster
®
Eco Series pump incorporates motor overload detection
designed to protect the motor from overheating. If the motor gets too hot it
will stop automatically to prevent motor damage.
To reset the motor, switch the power off for 30 seconds, and then return the power.