Dave Smith Instruments TETR4, Руководство по эксплуатации

Страница: 23 / 72

15
Choosing “Q LR34” is similar to Quad, but voices 1 and 2 retain whatever
panning effects are present in the assigned programs and the stereo outputs of
those voices are present at both the Left and Right outputs.
PotMode: Relative, Passthru, Jump –
Tetra’s Cutoff, Resonance, and Volume
controls are potentiometers or “pots.” There are three pot modes to determine
how the synth reacts when the programmable parameters—Cutoff and
Resonance—are edited. (Master volume is not programmable, so these modes
don’t apply.)
When set to Relative, changes are relative to the stored setting. In Relative
mode, the full value range is not available until either the minimum or maximum
value and the respective lower or upper limit of the pot’s travel is reached.
For example, the Resonance parameter has a value range of 0 to 127. Let’s say
the physical position of the Resonance pot is the equivalent of a value of 100. If
you switch to a program that has a stored Resonance setting of 63 and turn the
pot all the way up, it will only go to 90. To get to the maximum value of 127,
you first have to turn down until the value is at the other extreme and the pot is
at the limit of its travel (in this case, 0 and fully counter-clockwise,
respectively).
In Passthru mode, turning the pot has no effect until after the edited value equals
the preset value (that is, until the edited value “passes through” the stored
value).
Jump mode uses an absolute value based upon the position of the pot when
edited: turn a pot and the value jumps immediately from the stored value to the
edited value.
Balance V 1 - 4: -14…+14 —
Adjusts the left/right balance of each voice by
approxi/- 4 dB.
Basic Patch —
Press the W
RITE
button to load a basic patch into the edit buffer.
(The patch will not actually be written to the current program location unless
intentionally written to memory in Program Mode using the W
RITE
button.)
Reset Globals —
Tetra does not have a full hardware reset, but select this
parameter and press W
RITE
to reset the global parameters to their factory
defaults.
MIDI SysEx Dump: see table —
Allows dumping of programs and combos in
SysEx format via MIDI.