Dave Smith Instruments Pro 2, Руководство по эксплуатации

Страница: 22 / 152

12 Global Settings Dave Smith Instruments
For example, the
Resonance
parameter has a value range of 0 to 127.
Let’s say the physical position of the
Resonance
pot is the equivalent of
a value of 100. If you switch to a program that has a stored Resonance
setting of 63 and turn the pot all the way up, it will only go to 90. To get
to the maximum value of 127, you first have to turn down until the value is
at the other extreme and the pot is at the limit of its travel (in this case, 0
and fully counter-clockwise, respectively).
In Passthru mode, turning the pot has no effect until after the edited value
equals the preset value (that is, until the edited value “passes through”
the stored value).
Jump mode uses an absolute value based upon the position of the pot
when edited: turn a pot and the value jumps immediately from the stored
value to the edited value.
16 . Footswitch Polarity: Normal, Reversed—
There are two types of
momentary footswitches, normally open and normally closed. Either
type can be used with the Pro 2’s Sustain switch input. Not sure which
type you have? If the behavior of the footswitch is the opposite of what
is expected—that is, down is off and up is on—changing this setting will
correct that.
17 . Footswitch Function:
Sustain, Arp Hold On/Off—
The footswitch can
be used for sustain or to turn arpeggiator hold on and off.
18 . Pedal Polarity: Normal, Reversed—
This allows you to accommo-
date certain models of expression pedals that behave in a way that is the
opposite of what you might expect due to their polarity. (Pressing down
on the pedal decreases rather than increases modulation, for example.) If
this is the case with your expression pedal, choose the appropriate setting
to correct it.
19 . Pedal Function: Breath Control, Foot Controller, Expression, Master
Volume, Filter 1+2: Full Range, Filter 1+2 Filter: Half Range—
Sets the
function/destination for the Pedal 1 input. An expression pedal can be
routed to any destination using the modulation matrix. See
Modulation
on page 44 for more information.
20 . Aftertouch Enable: Off, On—
When on, the Pro 2 will receive and
transmit aftertouch data via MIDI.