FIGURE 6
Safety Stop
SAFETY PRECAUTIONS
1) Read through these instructions again insuring that all steps were completed.
2) Recheck and tighten any loose bolts or fittings.
3) Check to see that all top stabilizer channels are securely fastened to the tops of the stationary sections.
4) Check to insure that the end stops are securely fastened to the rail assemblies.
5) If attaching stationary section to wall make sure to follow manufacturers recommendations.
LOADING FILES
Loading a Bi/Tri Slider system in the correct manner is very important. It balances the paper weight load
throughout the entire system and minimizes the odds of having to move the rolling sections every time the system is
accessed. Careful planning of this phase of the installation will make filing and retrieval a lot easier.
It is recommended the system be loaded first from the left rear section followed by the first rolling section on the
left side of the Bi-Slider. If a Tri-Slider is installed, next load the first rolling section on the left side of the front row
(See figure 7)
.
Repeat loading from the rear to the front until completed.
RE-LEVELING THE DATUM BI/TRI SLIDER SYSTEM
It rarely occurs; however, after the Bi/Tri Slider system has been loaded, the rolling sections may begin to move
or creep on their own. While this problem is more annoying than hazardous, it may be corrected by re-leveling the rail
assembly. The Datum Bi/Tri Slider system has been designed so that the deck plates can be easily removed for access
to the leveling glides.
To remove the deck plates, move the rolling sections to one side. Then, insert a slotted screw driver into the slot
provided on the decking and with even pressure pull the deck plates up and remove.
Next, re-adjust the leveling glides by turning them one-quarter turn at at time either raising or lowering the rail
assembly to the desired height to stop the unwanted movement. It is very important that all leveling glides maintain con-
tact with the floor. When this adjustment has been completed, re-install the deck plates.
If other problems occur which have not been addressed in these assembly instructions, please call
Customer
Service at 8
88-891-1970 x 8958
.
Thank you for purchasing and installing this
s
ystem.
1
2
3
4
5
6
7
8
9
1
2
4
5
7
8
10
11
13
3
6
9
12
BI-SLIDER
TRI-SLIDER
FIGURE 7
BI-SLIDER
TRI-SLIDER
11
American Filing Solutions P.O. Box 891719, Temecula, CA 92589 Toll Free: (888) 891-1970 x 8958 Fax: (888) 891-9970 Email: [email protected] www.FilingToday.com
