M-01335, Rev. A
Page 11
6.1
Failure Messages
Failure messages are described in Table 2. If any of these messages are displayed, contact your
nearest Authorized Service Center or call Datron directly at (800) 287-5052.
Table 2. Failure Messages
Failure Messages Displayed
on Screen
Reason for Message Display
Possible Solution
CODE: 01 AZ & EL
Both AZ and EL index
switches/motors failed.
Contact nearest Authorized
Service Center or call Datron
at (800) 287-5052
CODE: 02 AZIDX
AZ index switch/motor failed.
CODE: 03 ELIDX
EL index switch/motor failed.
CODE: 04 A2D
Fault in the analog-to-digital
converter.
CODE: 05 XRATE
X gyro rate sensor failed.
CODE: 06 YRATE
Y gyro rate sensor failed.
CODE: 07 ZRATE
Z gyro rate sensor failed.
CODE: 08 PLEVL
Pitch level sensor failed.
CODE: 09 RLEVL
Roll level sensor failed.
CODE: 10 LNBFV
Failure of the R-hand/L-hand
polarity of the LNBF.
?
Repair or replace coax
?
Check receiver voltage to
LNBF
7.
Precautions
?
Do not open or remove any part of the antenna control unit or the antenna/radome assembly.
There are no user serviceable parts inside.
?
Operate the antenna system on a clean, continuous 12 VDC supply only. Fluctuations in voltage
can degrade performance.
OBSERVE PROPER POLARITY ON THE POWER
CONNECTION.
?
To locate the authorized dealer nearest you, f you are in need of assistance, contact Datron/Transco
Inc. Customer Service Department at 1-800-287-5052.
?
Turn antenna system OFF after acquiring signal if vehicle is to be stationary for a long time. Power
off will reduce power drain and extend operating life of antenna and vehicle battery.
