DATEC ACP-5010RDS, Инструкция по эксплуатации

Страница: 4 / 18

FRONT PANEL
3
Attaching the front panel
1. Holding the panel at its top and bottom edges.
2. Attach one side of the panel lightly first, then push the other side
of the panel into the unit.
3. Do not press the panel hard against the unit. It can be attached
by pressing it lightly. And beware not to drop it.
Keep in mind:
If it works malfunction, take the panel off and put it back again.
Do not touch the contact pins on the rear of the front panel, this
can cause contact errors. If the contacts are not clean, clean
contacts with a cotton swab dipped in alcohol.
Do not expose the front panel to direct heat or cold.
Be careful not to splash juice or other soft drinks into the car
audio.
Do not apply too much force. Otherwise, the panel may be
damaged.
Never take the front panel apart.
Detaching the front panel
1. Press the release knob to open up the panel.
2. Holding the middle upper side of the panel, pull it straight out
towards the arrow direction.(See the figure)
3. The red lamp blinks to tell you that the front panel has been
detached.(It could be stolen)
4. Keep the front panel in the supplied protection case.
1