Datcon DT9102 B, Руководство по эксплуатации

Страница: 19 / 60

DT9102 B
5.4. Connecting the battery pack
The DT9102 B is powered by a built in DT4V5BAT type
intrinsically safe replaceable battery pack, which is not
connected to the clock when delivered. Before using the
instrument, the battery pack should be connected to the
clock.
The battery connection or replacement can be
accomplished even in hazardous areas.
Do not use other battery type!
The following figure shows the connection:
Wiring plan, connecting
the battery pack
Be careful with the polarity
of the cables.
1. Push the cable end into the terminal assembly as far as
possible. By pushing the wire in, the self-closing connection
is being established.
2. Check it by pulling it outwards slightly.
Checking the
connections Check if the cables are connected properly (have you
connected all the cables, have you connected them to the
right place, are not the cable ends touching each other).
Wrong connection does not cause any malfunction.
Injury due to faulty wiring may causes malfunction only
after discharge of puffer capacitor (approx. 15 minutes).
This can be avoided by the correct polarity connection.
20180905-V1
19