Datawell BV RX-C4, Руководство пользователя

Страница: 15 / 49

15
4 Configuration and receiving data
This chapter describes how to configure the RX-C4 and receive data. For a description of the
normal operation of the RX-C4, refer to
paragraph 4.2 . To configure the RX-C4’s reception
frequency and receiving mode, refer to paragraph 4.1.1 and paragraph 4.1.3 .
When the RX-C4 needs to be connected to a LAN, it is very important to correctly configure the
RX-C4’s network settings before connecting the receiver to a LAN. The network settings are
discussed in
paragraph 4.1.4 .
4.1 Configuration
All of the RX-C4 settings are accessible and configurable from the configuration menu.
The following paragraphs describe how to navigate through the configuration menu.
To navigate through the configuration menu, three buttons on the front panel are used:

the “up/speaker” button, indicated by ▲.

the “menu/select” button, indicated by

.

the “down” button, indicated by  .
To activate the configuration menu, push and hold down the “

” button. After a few seconds
of holding the “

” button down the receiver will enter the configuration menu as shown in
figure 4.1.
Figure 4.1. The top menu with the EXIT function selected.
This is the top menu. From here, the memory, info, frequency and network settings can be
accessed. The ▲ and

buttons are used to navigate through the menu items. The currently
selected item is indicated by capital letters and “[ ]” brackets. When editing numbers (for
example when changing the reception frequency), the currently selected digit of the number is
underlined.
To select an item (or edit a digit), the

button is used. By default, the [EXIT] function is
always selected. This function will save any changed settings and exit the configuration menu.
NOTE : Any settings changed using the configuration menu are only saved to the non-
volatile (EEPROM) memory by exiting the top menu. It is therefore very important to
always properly exit the top menu after changing any settings. If this is not done properly, the
settings will not be remembered after a power-loss or remote reset.