ADIO WIRELESS BRIDGE USER’S MANAUL REV. 02
11
For the radio with Analog
outputs:
1.
Set the channel type
2.
Set the channel token value to match the value of the input channel token.
3.
Set pkts.en parameter to 1.
4.
Optional: Use set store to save the configuration
Example:
Figure 7 shows a setup for two radios. COM44 is the information COM port of Radio A and COM57 is the
information COM port of Radio B. In this example, Radio A is the input radio and Radio B is the output
radio. The same value was used for the channel tokens on all channels in this example. The channel
types on Radio B were set to analog outputs (type 2) and the pkts.en command was set to 1.
Fig. 7 Typical 4 Channel Analog input to Analog Output Signal Bridge