Datavideo RMC-300C, Инструкция по эксплуатации

Страница: 12 / 32

12
18. Please change the IP address of the selected PTC camera which is shown in the IP address column to
192.168.100.xxx (xxx represents 2~254).
19. Please press the “Save” button and then please reboot the PTC camera which the IP address is
modified.
20. Please set the remaining 23 cameras in Fixed IP Mode.
21. Please go back to the main interface of the RMC-300C App and then please press the “Save” button.
After that, the RMC-300C App will memorize current order of the PTC cameras.
22. Once the RMC-300C App is opened next time and the Load button is pressed, the system will load the
latest pre-saved order of the PTC cameras. From now on, users can use RMC-300C to control up to 24
cameras simultaneously.
3.2 Important Notices
1. Important notices before connecting the RMC-300C.
 The Ethernet cables must be connected at first and then the RMC-300C can be powered on.

After the RMC-300C power-on is completed, users can open the RMC-300C App for the Tablet. If the
App is opened before the connection is finished, the RMC-300C can not be connected normally.
2. The HDMI output signal for the RMC-300C can sustain for less than half an hour. After that, there is no
HDMI output signal.
3. After the preset is recalled, if there is any control that is done for the PTC camera, the light of the LED
indicator for the preset will disappear.
4. Due to that the factory default IP address for the PTC camera is 192.168.100.100, please remember to
search and modify the IP address by the DVIP Network config software before establishing the
environment for the RMC-300C. After that, the IP address can be modified by the RMC-300C App. The
reason is that the RMC-300C App can not find all cameras with the same IP address just as the DVIP
Network Config.