- 16 -
6.
HP-3 Connections & Controls
The HP-3 headsets are designed for the cameraman to communicate with the director. The HP-3 should be
connected to the 5-PIN XLR connector on the AD-2 (S/P/J). The Multi Transmission Adaptor Box (AD-2) then
transmits audio signals to and from the ITC-100 Intercom System via the CCU-100 Camera Control Unit.
6.1 Features
•
Reference quality, closed ear monitors
•
High suppression of ambient noise
•
Soft, circumaural ear pad
•
Noise cancelling microphone
•
Condenser omni-directional microphone
capsule
•
Very high gain-before-feedback
•
Flexible gooseneck mic boom for optimal
positioning
•
Single exit, plug-in cable assembly
7.
Frequently-Asked Questions
This section describes problems that you may encounter while using PTC-120. If you have questions, please
refer to related sections and follow all the suggested solutions. If problem still exists, please contact your
distributor or the service center.
No.
Problems
Solutions
1.
Is there a defined system boot order for the
CCU or any special care that needs to be
taken into account of?
1. The recommended boot order is to turn on PD-6
first and then the rest of the devices.
2. Please make sure the 4-PIN XLR power cable is
the CCU proprietary cable, which is different from
the general XLR power cable.
3. It is recommended not to rewire the device
while the power is connected; any change of the
wiring should be done only after the power is
disconnected.
2.
The AD-2 handset does not issue side tone
sound.
Please purchase AD-2 device of Version GB717-SL-
B or later.
