Datavideo BC-200T, Инструкция по эксплуатации

Страница: 37 / 44

37
8. RMC-180 Camera Control Unit
The RMC-180 PTZ Camera Controller is designed to control at least 4
Datavideo Pan Tilt Zoom (PTZ) cameras such as the BC-200T.
The four RJ-45 ports provided on the RMC-180 rear serve to connect BC
cameras, thus allowing the user to use any RJ-45 cable to connect the
RMC-180 to the RS-422 port located on the BC
camera’s rear panel. The
communication protocol is VISCA.
Note: Before connecting the camera to these channel ports, please set
bit 4 of the camera DIP switch located at the bottom to OFF.
Direct Connection to Camera
To use the RMC-180 PTZ Camera Control Unit to directly control the BC-
200T camera, connect the RS-
422 port on the camera’s rear panel to
the RJ-45 port of the RMC-180 using any RJ-45 cable. The RS-422 wiring
scheme is shown below.
RMC-180 Controller
(RJ-45 Port)
BC-200T Camera
(RS-422 Port)
GND 1 White/Orange White/Orange 1 GND
NC 2 Orange Orange 2 NC
TX- 3 White/Green White/Green 3 RX-
RX- 4 Blue Blue 4 TX-
RX+ 5 White/Blue White/Blue 5 TX+
TX+ 6 Green Green 6 RX+
NC 7 White/Brown White/Brown 7 NC
NC 8 Brown Brown 8 NC