PREPARING FOR THE INSTALLATION
17
Chapter 2
Preparing For the Installation
Before you start installing Touch Terminal, read the following instructions.
• Tango Series do not support PCI slot.
• Do not insert or remove any device or component from the Tango Series while the power is
turned on.
• If using Tango Series in a dusty environment, clean the Touch Terminal regularly.
• Only USB devices are Hot Swap capable. Be sure to turn off the power of the touch terminal
and the device before making any connection or disconnection.
• The spill proof design of Tango Series conforms to IP65 standard (Front panel only).
• Always seek the help of authorized service personnel in disassembling the terminal. The
manufacturer will not be held responsible in the event of damage caused by an unauthorized
person.
• Before installation or disassembling of the terminal, ensure that the power is turned off.
Otherwise, electric shock may occur and may void the warranty.
• For systems preloaded with WEPOS/POSReady/Windows Embedded on the HDD (O/S
pre-installed as an option), the manufacturer provides an optional recovery DVD with the
preloaded operating system delivered with the Touch Terminal. The System Integrator
shall take care of software restoration after an OS recovery. A manufacturer-supplied USB
interface COMBO drive will be required for such action. Other brands of COMBO drive may
require a specific driver different from what is supported in the recovery DVD.
Please use
the recovery DVD for rescue operation only. Using it otherwise may wipe out whatever
is stored in the HDD
. All upgrade device drivers needed for manual installation are
available in the subfolder “\drivers” in the OS recovered HDD. Then follow the instructions
from your system integrator for software recovery.
System Default Settings
The following is the information on default settings for Touch Terminal serial ports.
3F8
2F8
3E8
2E8
IRQ4
IRQ3
IRQ5
IRQ10
Содержание ARC Series
