iboot-poe-p_v190422w
iBoot-PoE-P
Page 5
2. Hardware Installation
2.1.
Auto Configuration Sequence
In most cases, the iBoot-PoE-P can completely configure itself on initial installation to identify all network
elements and automatic reboot of failed devices. For the best results follow this sequence when installing
the iBoot-PoE-P for the first time.
1. Connect the PoE OUT connection of the iBoot-PoE-P to the PoE powered device to be controlled
2. Connect the Net IN connection of the iBoot-PoE-P to the network switch or PoE injector
Auto Configuration can also be initiated via the web page setup. See Section 5.5
2.2.
Hardware Connections
iBoot-PoE-P supports 10/100/1000 Ethernet using the cable supplied, or other suitable unshielded twisted
pair (Cat 5-6) cabling.
Power is derived from either the PSE, such as a PoE Network Switch or a PoE Injector.
Connect the PoE OUT connector to the PoE Device to be controlled (PD); Camera, Access Point,
Phone, etc.
Connect the PoE IN connector to the PoE Power source (PSE); PoE Switch, Midspan or Injector
Ethernet LED Displays
NET IN connector
Green LED indicates Network Activity
Amber LED indicates 1000Mbps Speed
PoE OUT connector
Green LED indicates Network Activity
Amber LED indicates PoE-P power is available for the PD
