Your packing box should contain the following items:
The VisionSC-DP2 - Dual DisplayPort capture card.
(For latest drivers go to www.datapath.co.uk).
NOTE:
All plug-in cards are static sensitive and are packed in
antistatic materials. Please keep the card in its
packaging until you are ready to install.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
PACKING LIST
HARDWARE INSTALLATION
SOFTWARE INSTALLATION
You are likely to need a flat blade and/or a cross head
screwdriver for the installation of the VisionSC-DP2 card; it
would be useful to have these to hand before you begin.
Power down the PC (including peripherals), switch off at
the mains and disconnect all the cables connected to the
computer, noting the positions for accurate reconnection
Remove the PC cover.
Locate a vacant PCIe slot (x4 or higher) on the motherboard
and remove the backing plate (retain all screws) .
If in doubt consult your motherboard documentation to
correctly identify a PCIe (PCI-express) slot.
Remove the VisionSC-DP2 card from its packaging and
secure it firmly into the empty PCIe slot.
Screw the VisionSC-DP2 bracket to the back panel of the PC
and replace the cover. Connect the cable(s) (not supplied)
distributing the signals to the connectors on the
VisionSC-DP2 card.
Reconnect all cables to the PC.
Download the the required driver
install.exe
from the
Support pages on the Datapath website and follow the
Installation Wizard instructions as prompted.
We suggest that you regularly visit the Datapath web site
for information on updated drivers.
www.datapath.co.uk
It is strongly recommended that you read the detailed
help instructions on completion of the installation. Each
help topic may be printed for ease of use.
FL
Y-
VSC-EN3-
V1.0
