Your packing box should contain the following items
The VisionRGB-E2S dual channel capture card.
2 x DVI-VGA, 1 x DVI/Component and 1 x DVI/HDMI
Adapters.
(For latest drivers go to www.datapath.co.uk).
NOTE:
All plug-in cards are static sensitive and are packed in
antistatic materials. Please keep the card in its
packaging until you are ready to install.
You are likely to need a flat blade and a Phillips head
screwdriver for the installation of the VisionRGB-E2S card;
it would be useful to have these to hand before you begin.
Power down the PC (including peripherals), switch off at
the mains and disconnect all the cables connected to the
computer, noting the positions for accurate reconnection
Remove the PC cover.
Locate a vacant PCIe slot (x4 or higher) on the motherboard
and remove the backing plate (retain all screws).
If in doubt consult your motherboard documentation to
correctly identify a PCIe (PCI Express) slot.
Remove the VisionRGB-E2S card from its packaging and
secure it firmly into the empty PCIe slot.
Reconnect all cables to the PC then connect the cable
distributing the RGB or DVI signals to the connectors on the
VisionRGB-E2S card located on the back panel.
Power up the PC and commence the software installation.
Screw the VisionRGB-E2S bracket to the back panel of the
PC and replace the cover.
Connect the cable(s) distributing the RGB or DVI signals to
the connectors on the VisionRGB-E2S card located on the
back panel. Reconnect all cables to the PC.
PACKING LIST
HARDWARE INSTALLATION
SOFTWARE INSTALLATION
Download the the required driver
install.exe
from the
Support pages on the Datapath website and follow the
Installation Wizard instructions as prompted.
We suggest that you regularly visit the Datapath web site
for information on updated drivers.
www.datapath.co.uk
It is strongly recommended that you read the detailed
help instructions on completion of the installation. Each
help topic may be printed for ease of use.
