HMI BUTTON CONFIGURATION
PRODUCT REFERENCE GUIDE 4
HMI BUTTON CONFIGURATION
Button Teaching Procedure
The Run LED will blink until the Teaching procedure is entered (e.g. device factory
default).
Long press (> 4s, until the red LED on HMI lights up) the HMI Button to enter the Teach
-
ing procedure.
1. GOOD objects required to be taught (green
LED and green spot blink).
2. Place the GOOD object in front of the Aiming
System.
3. Place the trigger sensor properly. The Trigger
LED indicates object detection.
4. Short press (< 1s) the HMI Button to acquire
the image. More than one GOOD object can
be acquired. It is suggested to acquire one
image per GOOD object instance. Camera
parameters are auto-adjusted on the first
acquisition only.
5. Long press (> 4s, until the red LED on HMI
lights up) the HMI Button to start acquiring
NO GOOD objects. The red LED and the red
spot start blinking.
6. Place the NO GOOD object in front of the
Aiming System. Check the Trigger LED.
