Datalogic VLASE IR 1109-1 42 Series, Руководство пользователя

Страница: 70 / 136

USE AND OPERATION
62
VLASE™ IR
Sequence Using Command Box
Turn ON the main power supply switch in the back panel of the control rack. The laser
marker turns on and goes in booting-up state. During booting up state, the status LED
on the control rack blink green.
Wait until booting-up has ended: the status LED on the control rack is steady green. The
laser marker is in WAIT FOR START state.
Figure 7: Wait for start state
Set the Command box input signals as in the table below:
EXT_KEY
EXT_ENABLE_A
EXT_ENABLE_B
HIGH
LOW
LOW
Steady
The status LED on the rack will be blinking orange for about 30 seconds (laser source
warm-up).
Wait until laser source warm-up finishes. The status LED on the rack will be steady
orange. The laser marker is in STANDBY SHUTTER CLOSED state.
Figure 8: Standby Shutter closed state
CAUTION
Controlling the laser marker states using the Command Box connector on
the control rack back panel requires that the Key and Enable Selectors are
set to fixed position 1.
STATE
COMMAND BOX INPUT
STATE
KEY-ENABLE
SELECTOR
STATUS LED
STANDBY SHUTTER
CLOSED