Datalogic SG4-RB2-050-OO-W, Инструкция по эксплуатации

Страница: 19 / 95

12
2.8 SAFETY INFORMATION
For a correct and safe use of the safety light curtains of the SG BODY series, the
following points must be observed:
•
The stopping system of the machine must be electrically controlled.
•
This control system must be able to stop the dangerous movement of the machine within
the total machine stopping time T as per paragraph 2.6.2, and during all working cycle
phases.
•
Mounting and connection of the safety light curtain must be carried out by qualified
personnel only, according to the indications included in the special sections (refer to
sections 3, 4, 5, 7) and to the applicable standards.
•
The safety light curtain must be securely placed in a particular position so that access to the
dangerous zone is not possible without the interruption of the beams (refer section 3
–
“INSTALLATION MODE”).
•
The personnel operating in the dangerous area must be well trained and must have
adequate knowledge of all the operating procedures of the safety light curtain.
•
The TEST button must be located outside the protected area because the operator must
check the protected area during all the Test operation.
•
The RESET/RESTART button must be located outside the protected area because the
operator must check the protected area during all the Reset/Restart operations.
•
The OVERRIDE buttons must be located outside the protected area because the operator
must check the protected area during all the Override operations.
•
The external signaling lamp of the active Muting/Override must be visible from all operating
sides.
•
Please carefully respect the mounting instructions for the correct functioning of the Muting
devices.
•
The function of the external device monitoring (EDM) is active only if the specific wire is
correctly connected to the device.
•
Please carefully read the instructions for the correct functioning before powering the light
curtain.